New Bridge Support System
Our new Polycarbonate Bridge Support System is used in an elegant and contemporary manner to show off your frames to their best advantage. We have manufactured an easy to fit Polycarbonate Bridge Support for use on our Tinted Satin Ice panels. The bridge support is a clear polycarbonate with a light sandblasted finish. Emphasis has been put on the bridge section to give a very, very good support to a wide range of frames. Satin Ice is available in seven (7) pastel colours with the appearance of a light sand blasted finish. The colours available are: All panels can be custom made to suit any practice. |
|
 |
|
 |
These two elegant and contemporary panels are set off the wall with 45mm long spacers. Holes are cut into the sheet to act as the temple supports. The 110mm long Polycarbonate Bridge Support is fixed into place with a 6mm nut at the rear of the panel, which can not be seen once installed. Each panel is 600mm wide by 1200mm high, though they can be custom-made. The curve is consistent and will match into the next panel, and each panel displays 39 frames. |
|
|
 |
The 1m square panel is mounted off the wall with 45mm spacers. Holes are cut into the sheet to act as the temple supports. The 110mm long Polycarbonate Bridge Support is fixed into place with a 6mm nut at the rear of the panel, which can not be seen once installed. The panel displays |
|
|
 |
A close up showing the polycarbonate Bridge Support. |
|
|
Sunglasses courtesy of Saltwater Sunglasses |
|
